Acard PCI-to-IDE ATA-133 Manual do Utilizador descarregar pdf (Página 17)

Page 17

the “DS-33104\2K_XP_2003_Vista” folder, found on the driver CD,

onto a blank floppy disk then follow the directions below.

1. Setup the RAID Array prior to Windows installation.

2. Install the board and follow Microsoft procedures to install

Windows ®2000 accordingly.

3. Restart your system when prompted during Windows’ installation.

4. At the Windows 2000 screen, press F6 to install the driver.

5. Insert the driver diskette. Press S, then press Enter.

6. Select Silicon Image SiI 0680 ultra-133 Medley ATA Raid

Controller and press Enter.

7. Press Enter to continue and follow on-screen instructions to

complete installation.

For Existing Windows® 2000 Installation

1. Setup the RAID Array prior to driver installation.

2. Install the board and boot up Windows® 2000.

3. Insert the driver CD into CD ROM Drive, and they type

D:\DS-33104\2K_XP_2003_Vista (Note: “D:\” represents the

drive letter assigned to the CD-ROM drive you are using. If D is

not letter of your CD-ROM drive, substitute D with the correct

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Sem comentários

Acard PCI-to-IDE ATA-133 Manual do Utilizador Página 17